Qubino - Flush 1D Relay - Smart Control for doors and gates
Flush 1D Relay
The smart way to control your doors and gates
Lock induced paranoia?
Always looking for the remote controller to open the gate? Or do you often wonder if you closed the garage doors, after leaving home?
Seal away the fear!
Roll-up garage doors remotely. Open the gates of your home remotely, while on the way back home.
Quick and easy installation:
- Install the Qubino Flush 1D Relay behind a garage door switch
- Connect a door sensor, if your garage doors have it
- Configure it through your Z-Wave gateway
- Control your garage door remotely using your smartphone
Usage examples for Flush 1D Relay
With Qubino Flush 1D Relay you can wirelessly control your garage door, gate or entrance door of different power supply (110-240 VAC or 24 VDC). Use it to manage your gas water heater or as an intermediary that sends a PV signal to your heat pump, so it starts using photovoltaics energy and heating water to a higher temperature.
Do your doors have a sensor? Flush 1D Relay has an option to connect the sensor.
Have you closed the garage door after leaving your home?
From now on, simply make sure you have, by checking on your smartphone.
Qubino Flush 1D Relay cares about your home safety.
Be sure whether you've closed the garage door or gate and blocked the way into your home to intruders.
Z-Wave Frequency: 908.42 MHz (US)
Power Supply: 110VAC (24VDC)
Maximum Load for 110VAC: 2300 W / 10A
Maximum Load for 24VDC: 240 W / 10A
Power Consumption: 0.4W
Operating Temperature: 14 - 104 F